Engineered and
Built to Order

Mohawk Waste Heat

Waste Heat Recovery

Request a Quote

Let our Problem Solvers quote a boiler designed for your needs. Request a Quote

Give us a call at (620) 662-6693 or EMAIL US

Capacity: Customized for job specific conditions, with experience in designing units over 40,000 lb/hr.

Fuel Capabilities: Customized for application

Pass: 3-pass

Tube Type: Smooth Tubes or Rifled Tubes

Steam Design Pressure: 150 - 300 psig

Hot Water Design Pressure: Section I vessels 150 - 250 psig

Resources

General Description

Mohawk Three Pass Heat Recovery units are designed with a large diameter furnace for waste gas inlet temperatures to 2400°F with 2.5” heat transfer tubes.

Features

  • Customized design engineered for your specific solution.
  • Available with dual chamber design or supplemental firing
  • Temperatures to 2,400° F
  • Roller-bearing supported single-hinged rear door for total fireside access (except wetback)
  • Typical applications: low particulate levels, high inlet temperatures, and moderate gas side pressure drop.

Construction

  • 12 gauge tubes
  • 3/4″ tube sheets with 3/4″ ligament spacing
  • Furnaces thicker than ASME code requirements
  • Corrugated to help reduce the stresses associated with expansion and contraction

Quality

All Waste Heat Recovery Boilers are made with 12 gauge tubes, 3/4” tube sheets with 3/4” ligament spacing and furnaces thicker than ASME code requirements. All section I furnaces above 24” diameter are corrugated to help reduce the stresses associated with expansion and contraction.

Safety

Superior’s Waste Heat Recovery Boilers are trimmed and equipped with safeguards and code piping. Each boiler is inspected by independent code inspectors. Factory mounted and wired packaged burners are available from all burner manufacturers for supplemental firing.

Our Problem Solvers Explain

This site is registered on Toolset.com as a development site.